BlueMicro V1.x

Description

The BlueMicro V1.x is a simple breakout board for the Ebyte E73-2G4M04S1B module (nRF52832) so that the pinout matches that of the Arduino Pro Micro.

Processor and Module

The BlueMicro uses the nRF52832 from Nordic Semiconductors. For an overview of the features of this SoC, refer to Nordic's Product Page. The most important features are as follows:

  • 64 MHz Cortex-M4 with FPU
  • 512 KB Flash, 64 KB RAM
  • 2.4 GHz Transceiver
  • -20 to +4 dbm programmable TX Power
  • 32 configurable GPIOs

For a detailed description of the nRF52832, you can download the datasheet (533 pages).

The BlueMicro uses the Ebyte E73-2G4M04S1B module. This module is FCC and CE certified.
The module uses a PCB antenna, has an external antenna connector and makes 30 GPIOs available externally, 1 of which is reserved for the reset button. The bootloader and firmware may reserve additional GPIOs for specific functions (2 pins for serial, 1 pin for factory reset, 1 pin to put in DFU) For a detailed description of the module, refer to the manual.

If you want to replace the PCB antenna with an external antenna, the following antenna is the one that's designed by the module manufacturer. The manual indicate the small surface mount resistor that needs moving to disconnect the PCB antenna and connect the external antenna.

Bootloader

Although the BlueMicro can be programmed using the Nordic Software Development Kit and other commercial tools, we recommend using the open source Adafruit nRF52 Bootloader as the bootloader for the BlueMicro. The Adafruit nRF52832 Feather bootloader is fully compatible with the BlueMicro.

You can obtain the bootloader from the following locations:

  • release artifacts of the Adafruit Repo
  • release artifacts of the Forked Repo
  • Adafruit nRF52 Arduino Board Support Package
  • Community Add-on to Adafruit nRF52 Arduino Board Support Package

Pinout

PCB

TopBottom

Schematic

img

Edit this page